Hardware features Interface 1*GE WAN/LAN multiplexing. 1* GE LAN. 2.4G upli
| Hardware features | ||
| Interface |
1*GE WAN/LAN multiplexing. 1* GE LAN. 2.4G uplink interface, up to 300Mbps 5G uplink interface, the highest rate is 866Mbps |
|
| FLASH | 32MB | |
| SDRAM | 128MB DDR | |
| Button | 1*Reset reset button, hidden hole position. | |
| Indicators | ||
| Function | Definition | Color |
| Breakdown | Steady on: AP is disconnected from the internet. | red |
| Blinking: The AP is disconnected from the mesh network. | ||
| The internet | Steady on: The mesh configuration is complete and the network is reachable. | blue |
| Blinking: Mesh networking is in progress. | ||
| system | Blinking: during system startup | green |
| Steady on: The startup is complete and the mesh configuration is not enabled. | ||
| Signal strength indicator | Steady on: It is worse than other AP signals in the mesh network. | yellow |
| Antenna | 2*3.5DBI dual-band antenna.。 | |
| Wireless | Supports IEEE802.11B/G/N/AC with a maximum wireless speed of 1200MBPS. | |
| Wireless channel | 2.4G: 1~13 channels; 5.8G: 36-158 | |
| Wireless transmit power | ＜20dBm | |
| Power | DC 12V1A (built-in) | |
| Environmental requirements |
Working temperature: -5 ° C ~ 40 ° C, working humidity: 10% ~ 90% RH does not condense. Storage temperature: -40 ° C ~ 70 ° C. Storage humidity: 5% ~ 90% RH does not condense. |
|
| Software function | ||
| Operating mode | Router，Bridge、Repeater（Client+AP） | |
| QoS | WMM | |
| Wireless security | 64/128-bit WEP,WPA-PSK / WPA2-PSK ，AES/TKIP | |
| Wireless power conditioning | Support | |
| DHCP server | Support | |
| Protocol | Support for IPv4/IPV6 | |
| Andlink | Support | |
| Port forwarding | Support | |
| Equipment management |
Local WEB manage System status Software upgrade Factory reset Device manager setup Log Management Equipment statistics information |
|
| Diagnosis | Ping and tracert test | |
| Wireless |
Wireless basic configuration Wireless security configuration Wireless access control |
|
| Time synchronization NTP | Support | |
| Mesh automatic networking | The mesh router automatically recognizes that the user can choose to join the network on the web to complete the configuration. | |
| Support dual-band simultaneous networking | Support 2.4G and 5G for mesh networking at the same time, automatically select the optimal frequency band in different environments. | |
| Mesh optimal path automatic selection | Dynamically select the optimal data transmission path based on factors such as signal strength, interference, and bit error rate. | |
| Automatic identification of master/slave routes | After the user is configured for the first time, any router can be used as the master/slave router. | |
| Configuration and firmware auto sync | Automatically synchronize other routers after the primary router is configured, and upgrade other routers simultaneously when the primary router is upgraded. | |
| Intelligent roaming | Automatically select roaming mode according to the roaming protocol supported by different wireless terminal devices | |
| Dual frequency intelligent connection | Dual frequency is combined into one SSID, and the optimal frequency band is automatically selected when the wireless terminal device is connected | |
Previous：No data
Enya